K
Her Name is Frank
twisted minis
+1y
Bottom of the cab is pretty much stripped. Needs one last coat of stripper then it should be totally bare. I pulled the cab down to finish a few little details I overlooked before I coat the bottom. Thought it looked cool so I took some pics. Also you can see the finished rear cab wall.
3in2out
+1y
Lookin good man!
mexicant
+1y
lookin good bro !
johnny5
+1y
sweet
vegasyota94
+1y
sweet
rubber ducky
+1y
sweet
twisted minis
+1y
sweet
twisted minis
+1y
Okay, finished the floor today. I angled the front seat mount, and flor brace to make sure it doesnt hold the stock carpet up.
Relocated the harness ports.
I found another good cancer spot in the floor so I cut it out and replaced it. Was small, but that made me decide to pretty much strip the whole cab to try to find more. Just in case. I need to eliminate all rust if possible.
And whatever is on the bottom side of the cab, was on there good. I used almost a half gallon of aircraft stripped getting 3 different coatings off. And I found surface rust under all of that. Now I just need to wirewheel off all the rust and excess paint particles, and start welding...
Other than the frontmost part of the pan where your feet rest, where you can see I replaced it, the floor is pretty solid.
Relocated the harness ports.
I found another good cancer spot in the floor so I cut it out and replaced it. Was small, but that made me decide to pretty much strip the whole cab to try to find more. Just in case. I need to eliminate all rust if possible.
And whatever is on the bottom side of the cab, was on there good. I used almost a half gallon of aircraft stripped getting 3 different coatings off. And I found surface rust under all of that. Now I just need to wirewheel off all the rust and excess paint particles, and start welding...
Other than the frontmost part of the pan where your feet rest, where you can see I replaced it, the floor is pretty solid.
johnny5
+1y
looks good man
mexicant
+1y
man your goin all out seth , looks good