Mach 1 wheel question

Im looking into getting a set of Mustang Mach 1 wheels and I think I found a good deal on them. They are 17x9 so my question is would these be too wide for the front of my 97 ranger also would this rub when I turn. I am going to do a 4/6 drop.

i had 18X9 Bullitts which pretty much have the same offset and a 5" front drop and i did not rub at all. i did use 5/16" spacers tho

i have 20x9's and i used to have 275/45/20's for tires...they rubbed just a lil bit but just barely when fully cranked, but now i have 35 series and i dont rub at all...so im sure 17's wont be a prob at all.

yeah i roll 20s on a 3/4 at 40 series and have no rub ata ll youll be just fine

Hey does your truck have the 3/4 drop in your sig?

17x9's will be fine. i'm going 10.5 in the back soon.

yeah it does i wanna go lower so bad!