threads
Page 1 of 1
Ranger Exterior \  Grant Kustoms roll pan

Grant Kustoms roll pan

Ranger Exterior Ranger Tech
views 1544
replies 5
following 3
 
static94 avatar
static94   +1y
I seen on here a while back that the grant kustoms roll pan for a splash is bolt on. Or atleast i thought i seen it. I was wondering if anyone has put one on there truck and if they had any pics of how it goes on. i ordered one just shipped today. was just going to get ready for when it gets here
slammedxonair avatar
slammedxonair   +1y
They should just bolt in on the side of the pan. You might have to drill some holes but that should be about it.
static94 avatar
static94   +1y
Thanks. I dunno if you ever installed one or not but on my splash they have little tabs sticking out the back behind the bumper. What r they for. and to smooth out the rear do i just cut that off or what
slammedxonair avatar
slammedxonair   +1y
I've seen most people just cut those off, my parts ranger has a splash bed with a roll pan and those tabs were cut off.
snooptodd avatar
snooptodd   +1y


The little tabs are just one of the fender mounting points.
static94 avatar
static94   +1y
So can i just cut those off. what way would i use to keep the fender attached.
Page 1 of 1