Ugly Truckin B2600i Project

Searching Craigslist and found these beauties for a steal... Nissan Titan steelies 18x8 with 25mm offset.

Double check the fit. Newer Nissans have a smaller bolt pattern.

I just checked the center cap and it lined up to the lug nuts, thanks for the heads up ulrich

Wrong. Not a smaller bolt pattern, but a smaller center bore. The bolt pattern has been the same for a looooooong time.

Got some work done over the passed few weeks, but i noticed there is a vibration/resonating noise coming from the dash near the windshield. It becomes noticeable at 60+ mph and it is annoying. Does anyone know how to take off the cowl, is it just those plastic clips and screws under the hood or are there more on the inside behind the dash?


Latest update.
Master and slave clutch cylinder replaced.
Valve cover gasket replaced
Fuel filter replaced.
Tune up (cap, rotor, spark plugs)
Air Filter replaced
PCV valve replaced.

Next on the list:
lowering the rear with 3" angled block
grinding off hub tabs to mount the titan steelies
Install new/used driver seat.
Ill snap some pics in the morning

Just the ones under the hood...

thanks shavedog, I see your b22 on those toyota 18s... nice

Working on the inside now. I was going to just clean the carpet, but then I thought its just time and screws to clean it all.

Nice storage bin you have there

when your working out of a single car garage, you have to use whatever you can.