holy cold welds battman

this is my buddys damiens truck that im rebuilding for him been this way for 7 years

aired up













now with it aired out










last one for now this is the rearmost bed bolt this is how nuch it takes to keep the bed level can you say bent frame

pictures???

OMG!

wow! kinda scary some of those welds look like a little hammer could snap them off

the shock brackets did hahahaha

so on the redo will it lay out?

also forgot to get a pic will try toomorow the water oil seperator was not changed in 3 years it looked like somone dipped the cardboard filter in wet tar

yes it will lay full frame already has the front cross member raised but does not have the lower balljoints flipped all it will needto lay the front its 3/4" off the ground. im leaning tawards doing a full back half from the cab to fix all the probs easierthat way

wow that looks unbelievably unsafe, have fun with it man!!!

omg.. i can even weld better than that.. no joke.

i drove it today and when you drive it layed out it pulls very hard to the right but when you lift it it then goes straight wow watched the rear end move tonight when i played with the air system , it even bindes the pass side lower bar so bad it whont mve but it trys to bend it when lifted it does the same to the drivers upper <img src="{SMILIES_PATH}/icon_confused.gif" alt=":?" title="Confused" /><!-- s:? -->