Project "Suki" (91 B26i) HID's installed

97759 views
706 replies
84 following
K
Project "Suki" (91 B26i) HID's installed
iculookn42 avatar
iculookn42
+1y
i like those wheels! only wish I had the money to get them
beatmymini avatar
beatmymini
+1y
dude where did you get those clear tail lights? i've been looking everywhere for them and i cant find them at all.
91extcab avatar
91extcab
+1y
beatmymini (cody), i had rufus order them off the australia eBay page for me to be shipped from like taiwan... here you go... even a link to a set for you... :4|65:1|39:1|240:1318|301:1|293:1|294:200
beatmymini avatar
beatmymini
+1y
Nice. thanks man.
harris1 avatar
harris1
+1y
I like those wheels alot! how much r they?
91extcab avatar
91extcab
+1y
i think they were like 139 a piece or so. i dont remember... i just remember that one wheel was more than the set of z71's i bought...
91extcab avatar
91extcab
+1y
so today i went out and picked up a set of 99 ranger lights... dont ask me why they were cheap... they put out a crap ton of light compared to my stock 6054s, and the h4 projector wannabe replacements... i like the fact that i can now SEE... what i dont like is i think the 99s have more of a curved face than the 01s, not sure will have to side by side check them... and they dont really seem to look good when the grill is put on... with the grill off you can tell there is some kind of work being done... but you cant see exactly how bad the 99s dont match up... why havent i seen any of you guys knockin the 99s?! i'll take some pix tomorrow with the grill off and on and post them up for you guys to see my Epic Fail of the Day...
91extcab avatar
91extcab
+1y
So i went to pull a part here in washington this morning and grabbed me a pair of matching good condition 4x4 fenders for the mazda, and a pass side grey sun visor, both 4x4 endcaps, and the little plastic donut for the little ball on the end of the stick shift that goes into the receiver inside the tranny. here are the fenders on the truck, after rolling them with an aluminum bat...

new drivers

old pass

new pass


bodied b2600zx (josh) avatar
bodied b2600zx (josh)
+1y
NICE! ! Keep at er man! ! And keep these updates comin



-Josh
91extcab avatar
91extcab
+1y
they had a couple 4x4 mazdas out at the arlington pull a part when i went today... the gold one that i took the fenders off of had an in good shape 4x4 bed on it that i would have liked to grab if i had the extra bill they wanted for it and a way to get it home... i also looked for a dual fan electric fan setup to swap too but didnt find anything that i really liked so i went without the electric fans...