K
B2600 4x4 Project
bmzero
+1y
Thanks.
The shop will be 30'x50', with 14' eves to leave room for the 2-post lift.
-b
87_b2600
+1y
what motor did you put in there? I have the carbed version of the 2600
91b2200(cody)
+1y
302's are good motors...
my dad has this
and i know he loves his car. (its actually in the garage undergoing some stuff and is only goin to be a summer car when done) so i decided since i sold my old car and had 800 bucks to spend it on him for christmas this year for this
-BBK fender cold air kit
-BBK underdrive pulley kit(the nice polished ones)
-65mm throttle body,65mm egr spacer,with mathcing top n bottom intake all of which polished out. this kit was $660
my dad has this
and i know he loves his car. (its actually in the garage undergoing some stuff and is only goin to be a summer car when done) so i decided since i sold my old car and had 800 bucks to spend it on him for christmas this year for this
-BBK fender cold air kit
-BBK underdrive pulley kit(the nice polished ones)
-65mm throttle body,65mm egr spacer,with mathcing top n bottom intake all of which polished out. this kit was $660
bmzero
+1y
It started life as a 5.0L from a 1998 Mercury Mountaineer. At this point, it's mostly aftermarket except for the block and crank. Lunati provided most of the parts.
bmzero
+1y
That's going to look sick.
jmzcustomz (jeff)
+1y
Holy shat bro I just noticed you are in B-Ham. I may have to pm you next time I will be up that way to take a peak at this beast. I am just east of Jackson MS so really not too far. That v-8 is sick looking and will be beastly in this thing.
bmzero
+1y
Sounds good to me. Hopefully I'll have it back at my shop in the next couple of weeks.
lil89ram50
+1y
i thought you had a bed liner in there??
bmzero
+1y
That isn't my truck. That's one I saw at the Lucas Oil Off Road Expo in Pomona. I just snapped those pictures and posted them up because that's similar to how I'm going to do the bed in this truck.
-b
emjay
+1y
nice, I can def dig this setup.