Project:LOST WAGES **updated 4-20-10**

I really dig the way the dash rolls down acroos the top from the middle to the right. Should really nail the smooth look I am after. And, notice the huge empty space in the center. Lots of room for an "easy trim to fit". I use the term easy VERY loose in this situation.

If all goes well my next pics will be of the suicide doors installed

SWEET.

Stock tank had some unknown rust issues so I had to put in the fuel cell. This will eventually go under the bed

SWEET when we get to see that dash in the truck

I hope to start on it in a couple weeks...may take a while to get finished.

Was supposed to take my truck to get the suicides put on today but.....since I still have fuel pump issues, looks like that has been put on hold for the time being. So, I started on my dash today instead. 1 smoked drill, 2 wire wheels, and 3 hours and this is where I am at so far.


This freakin thing is huge!! Preliminary measurements show that about 9 1/2" will need to be cut out. The depth and height are pretty close to the Mazda dash measurments.

Ordered this bumper about a week & 1/2 ago. I hope to have this here in just a few days. Said take around 2 weeks to get it due to them having to stretch the ends to fit my 2wd fenders.

good progress man,

love the dash