'86 Dual Cab from AUS! Updated 27 Dec 08

14245 views
115 replies
42 following
I
'86 Dual Cab from AUS! Updated 27 Dec 08
toddluck's avatar
toddluck
+1y
i dig the guages
8
86dually
+1y
ok got defected

trucks now off the road

fronts gona be bagged, all 4 suicide doors, new motor, bodydrop to doors etc
8
86dually
+1y
ok got defected

trucks now off the road

fronts gona be bagged, all 4 suicide doors, new motor, bodydrop to doors etc

thread post photo

thread post photo
91b2200(cody)'s avatar
91b2200(cody)
+1y
looks like ya got pulled over ... kick a$$ truck man i didnt think those were factory..
90-b22dawg [andrew]'s avatar
90-b22dawg [andrew]
+1y
like the picture with the patrol car behind you
8
86dually
+1y
thread post photo

thread post photo

thread post photo

thread post photo


front down for 20s on stock spindles and arms without flipping bj's
jmzcustomz (jeff)'s avatar
jmzcustomz (jeff)
+1y
OMG I think I just ruined my shorts...yup I did. Sexxy ass camber. I am jealous more now than ever.
8
86dually
+1y
thread post photo

thread post photo


fronts almost down, i have to trim the torsion bar x member??? thought mazdas didnt have to touch any x member?
elbine69's avatar
elbine69
+1y
Damn you took the cab and box off to do some trimming haha. What crossmember are you talking about?
immortal1 (linn)'s avatar
immortal1 (linn)
+1y
I believe he is talking about the cross member that goes under the drive shaft, right at the end of the transmission. In the above pic it looks like it is sitting on the ground.

In answer to your question, I know mine gets scraped up pretty good, but did not think it was any lower than the frame rails.

Related Discussions in Mazda Projects