threads
Back To Page - Tennessee Wheel and Tire
Page 1 of 1
Tennessee Wheel and Tire \  narrowed rear end

narrowed rear end

Tennessee Wheel and Tire
views 1851
replies 6
following 4
 
landwhale avatar
landwhale   +1y
if want to run semi's with out widening my fenders how much would i have to narrow my rearend? we have already figured in 3 inched on each side and the 4 link is inside the frame.
brianbgboy avatar
brianbgboy   +1y
what year and make is your truck? later, brian
landwhale avatar
landwhale   +1y
its a 1995 chevy crew cab
brianbgboy avatar
brianbgboy   +1y
if you dont have the wheel faces milled down, 3" will be close. is it bodydropped?
liljlowrider avatar
liljlowrider   +1y
you will need to narrow it at the minium of 7 inches....
landwhale avatar
landwhale   +1y
not bodydropped just bagged. i think we could squeeze another inch but it'll be close
lockone avatar
lockone   +1y
You could almost get away with narrowing your rear end 3" on each side and then face milling the wheels. This will give you a total of 3.75" narrower on each side.
Page 1 of 1