K
8" rear flipkit?
krewzlo
+1y
Support it just to be sure. I think I have an extra belltech notch layin around if you are interested. I will check after dinner.
1fastlx
+1y
no real need to worry about the frame support, if you leave the bed on and do one side @ a time the bed will give you plenty of support for a small notch. but a set of jack stands under the back wouldnt hurt.
lockone
+1y
What he said will work...
onefasthoagie
+1y
about how long do you estimate it will take to cut out the cnotch with a dremel? it's the 11,000rpm model.
dragnasty
+1y
a really long time!....I would do the c-notch while you had the leaf srings undone for the flip. That way the leafs arent pulling on the rear of the frame.
lockone
+1y
With the dremel it will take an estimated 3 months to complete both cuts... ...and The way Nasty said with the leafs undone from the frame and axles is a really good idea unless the weight is on a stand....
onefasthoagie
+1y
ok i will do that! i got a beaver outback (behind the garage) and i know it only likes wood, but maybe if i put some sawdust on the area it will go to town c-notching it.
lockone
+1y
I have a beaver in our shop that is called a plasma cutter and it will fix your problems in a little under 1 min.....(insert evil laughing here)
onefasthoagie
+1y
yea well then it would take 28 hours and 1 minute to complete it then.
1fastlx
+1y
our plasma cutter has its own theme song, it a bad mother if u know what I mean. any welding shop in your area should have a plasma cutter, or you can use a sawzall. the dremel, leave it in the box lol