threads
Page 1 of 1
Hydraulic Suspensions \  Nissan Set-ups

Nissan Set-ups

Hydraulic Suspensions Q & A
views 1112
replies 3
following 2
 
foulmouth79   +1y
Ladies and Gents,

I got my hands on a 94 hardbody that's bodied and juiced on 19's. Overall not a bad daily driver, but doesn't have the most stellar setup. The front end is the one that's giving me fits. I can say the hot wrench was used a little much, needs to be redone. I know it needs at least upper control arms and cylinder mounts. If anybody's got any pics of their hydro set ups in the front, please post them up. I need some ideas and a direction on where and how i'm going to redo this thing.

thank you,

j
tre5   +1y
Here's how I did my old Mazda.
post photo
foulmouth79   +1y
Ahhh OK....I see you used the screw type mounts like you did on the s10 from a while back. How much for a set of those? If I use those I can just saith to tubular uppers and sleep better at night.
tre5   +1y
Actually, that is just a sleeve slid over an old prohopper cylinder and rests against the collar on the cylinder. I sell the ones that thread onto the Dice Suspension cylinders for $125 a pair.
Page 1 of 1