K
my other doored tacoma
topd taco
+1y
well my truck is back for another rebuild and hopefully the final lol
topd taco
+1y
this what i got so far
topd taco
+1y
topd taco
+1y
topd taco
+1y
starting to plate the transition
topd taco
+1y
new stage 2 racing clutch and new trans
topd taco
+1y
got my body mounts built and tacked in place
topd taco
+1y
still got alot to do but it is now a ROLLING chassis
xgolferdude
+1y
Edited: 2/22/2012 1:22:50 PM by xgolferdude
I say this not to hate but that transfer from your stock clip to 2x3 and notch is suspect... Just do a miter cut instead of that... Not saying the welding is bad but that has stress riser written all over it..
I say this not to hate but that transfer from your stock clip to 2x3 and notch is suspect... Just do a miter cut instead of that... Not saying the welding is bad but that has stress riser written all over it..
topd taco
+1y
Edited: 2/22/2012 9:49:11 PM by topd taco
--------------------------------------------
xgolferdude said:
Edited: 2/22/2012 1:22:50 PM by xgolferdude
I say this not to hate but that transfer from your stock clip to 2x3 and notch is suspect... Just do a miter cut instead of that... Not saying the welding is bad but that has stress riser written all over it..
--------------------------------------------
that transfer is more than beefy enough it is plated to hell and back, i could have cut all plates to shape and just used that with no 2x3 inside of it and still would be fine. and the angles of the notch left more thick wall metal to weld to than a higher degree angle butted together and is also plated to everything on here is pretty much an overkill for this little truck.
--------------------------------------------
xgolferdude said:
Edited: 2/22/2012 1:22:50 PM by xgolferdude
I say this not to hate but that transfer from your stock clip to 2x3 and notch is suspect... Just do a miter cut instead of that... Not saying the welding is bad but that has stress riser written all over it..
--------------------------------------------
that transfer is more than beefy enough it is plated to hell and back, i could have cut all plates to shape and just used that with no 2x3 inside of it and still would be fine. and the angles of the notch left more thick wall metal to weld to than a higher degree angle butted together and is also plated to everything on here is pretty much an overkill for this little truck.