Titan Z

1st thing im doing is lowering the motor 3/4" then raising trans 3/4",when you z it 1 1/2" it will be level.to make things easier i contacted jimmy about making these 1 off mounts to lower the motor

Here are the new spindles

A little update now I have all the stuff to actually start cutting the frame.Had to wait to get the front end back together to see how much room is going to be under the fenders and hood layed out.im hoping to z it 3" and lay it out on the rockers on 26's something that hasnt been done.so here are the new uppers and lowers.

a couple new ones still mocking up the upper tabs to the correct the camber.then its time to finally z it

sic project!

Edited: 12/15/2010 11:05:45 AM by FoolInjected

New update pics. I decided to go ahead and Z it 3" and section bottom of frame 1 1/2" to set it on the rockers,still have to redo front tubs another 1 1/2" to suck the wheels up more so it will lay out on the rockers

love your build cant wait to see it done, here is mine not on 26s yet but will be after xmas. its firewall back frame with a chevy front clip.