Michigan Metal Works ---- Updates : Please Read.

Your a hoss taylor

that kit is awesome..how much does it run?

Edited: 7/27/2011 10:26:12 PM by Chopped Mazda

**** for the entire kit. 16 pieces, all cut from .250 plate.



Taylor

damn taylor...thats cheap...so no trimming of the frame for the upper bag mount? would it all work with djm lowers?

You cut all of your stock stuff off the frame and put this in its place. No frame trimming or pocketing at all.

I do not know for sure if this would work with djm lowers.




Taylor

Just wanted to share this little piece i made recently.

This is for a wammy tank plug setup that jeremy over at Tre5 customs is doing on a car soon. I ended up turning the aluminum and steel at the same time, so they were the exact same diamiater, then candy coated the aluminum, and milled the customers club logo out of the cap. The steel part will be welded into the tank, then chromed again.

I think little touches like this are pretty awesome.

i want a set! how much travel do the jeebus joints get over the screw in joints?

Over the screw in joints its about 10-12 degrees more, it depends on which brand you buy to be honest, there not all made the same, but the speedway ones like you have, you will gain about 10-12 degrees more.



Taylor

Big fan of all your work. Keep it coming!

i may need them since with the speedway screw ins, i get not quite enough lift to turn. plus i still wana do those arms like we talked about.