Michigan Metal Works ---- Updates : Please Read.

Hey have u done anything with the rear parts yet? And did u get that truck this weekend?

--------------------------------------------

1lochevy said:

Hey have u done anything with the rear parts yet? And did u get that truck this weekend?

--------------------------------------------

Just working on machining your rear end jig for the narrowing. Watts is all cut and done, as is all the bracketry for the link stuff.

Yea, i got the 08 if thats what your talking about. Showed up on friday.



Taylor

Hey taylor i called and left you a message. i need some C10 upper control arms but i need them 1/2" wider. standard ball joints are fine i dont need jeebus joints. my phone number is on your voicemail or email me

Got it!

Your order is in and in the works!


thanks



Taylor

I got my arms today i asked if i had any more they said that was the only boxi had there.


Im going to power coat the arms do i need to keep the coating out where the bushing go and the ball joint?

Yea, its best to keep as much of the powder coat out of the bearing and ball joint openings. Its not such a big deal for the bushing ends however, those haev plent of room, but the ball joints and bearings are tight tolerance fitments, so they are a bit more critical.


Taylor

ttt

hey man whats my stuff lookin like?

Not bad, just getting this front end kit all wrapped up. I cut one and tested it, then made a few changes to it now im cutting the final one. Did you ever send those brackets to me so i could return them? I havent seen them yet....




Taylor

i think they shipped out today taylor