Page 1 of 2
Build-Ups \ 2000 Nissan Frontier bd on 22" 24"2000 Nissan Frontier bd on 22" 24"
views 792
replies 14
following 9
LastChanceFabrications
+1y
Heres a project our shop is doing. Its bd 3" and has been converter to lower A arms using uniballs. Custom back half and the frame rails are being used as the air tank. We are in the process of building custom upper a arms using uniballs also. The rear suspension is a one off wishbone setup using balistic fab jonny joints.
pugz
+1y
Edited: 2/28/2010 1:09:16 PM by pugz
sick..... u should post a thread on this at........................................................................... VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVvvVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
sick..... u should post a thread on this at........................................................................... VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVvvVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
LastChanceFabrications
+1y
---------------------------------------------Originally posted by 974doorHow much for a set of those lowers?---------------------------------------------
Well those arms require some fabrication. For the whole conversion kit ur looking at $900 for the arms and everything needed to make the conversion but u will need to have someone that knows how to weld to complete the conversion. with our upper and lower arms we are getting 14" of lift out of the front suspension! to get the uppers also with uniballs its an additional 400.
Well those arms require some fabrication. For the whole conversion kit ur looking at $900 for the arms and everything needed to make the conversion but u will need to have someone that knows how to weld to complete the conversion. with our upper and lower arms we are getting 14" of lift out of the front suspension! to get the uppers also with uniballs its an additional 400.