info on laying out a ranger on 20's w beams

yeah it was a mess when i got it too i drove it around for a lil bit the tans had no park and was starting to fuck up that was like 05 it had 18's and 20's on it and was about 2" from layin

--------------------------------------------- Originally posted by framedranger You also have to bend the driver side tie rod around the pitman arm ....for camber problems go to napa and buy 4deg camber bushings and your camber wont be that bad at all here are some pics of the notching above the beam on the driver side --------------------------------------------- Generally you weld in a piece of tubing when cutting out a section of frame. You are only half done.

--------------------------------------------- Originally posted by iLLblazer --------------------------------------------- Originally posted by framedranger You also have to bend the driver side tie rod around the pitman arm ....for camber problems go to napa and buy 4deg camber bushings and your camber wont be that bad at all here are some pics of the notching above the beam on the driver side --------------------------------------------- Generally you weld in a piece of tubing when cutting out a section of frame. You are only half done. --------------------------------------------- Yup I agree Its on my to do list before hitting the road again this summer.Thats not the frame its actually the crossmember below the engine but noneless your right it should be welded up