K
baggin the HHR
garagebuilt
+1y
it should be rolling again by gator drag but i doubt it will be tubbed. dont see man low hhrs but they look good
minitrucker04
+1y
are u sure its going to be ready for gator drag?
garagebuilt
+1y
it goes slow because me welder never shows up. but it will be ready
ptman2002
+1y
nice to see you doing the rear end. gives me ideas on how to go about doing mine on my PT one day.
minitrucker04
+1y
they always blame the welder
garagebuilt
+1y
here is some of what i have done. should be finished tonight. i made this 2 link where the bag sits closer to the front to get more lift. i also raised the hubs so the bars sit almost parallel to the ground at mid stroke to keep the wheel from moving too far forward when layed out. still need to trim some stuff on the inner fender and maybe tub it. got about 1.5" lower without trimming anything
myfirstGMC
+1y
Very cool.
JPeventsxx
+1y
Will it be at Gator Drag?
artsar
+1y
since its the same swing arm thats in my car can you take some measurements of that and send them my way? I am getting a beater for winter so it will give me time to get the car a bit lower. Looks alot better now though. Me likey!
garagebuilt
+1y
yeah i hope i get it together before gatordrag even if i gotta stay up all night friday. i got everything welded up except shock mounts yesterday. then it needs paint. it for sure wont be tubbed, i wont have time plus the tire may hit the gas filler neck. artsar i will take measurements today. i narrowed it 5/16" and lengthend it like 2 inches.