64 impala

about 3 inches from the ground and clear the tires about 4 inches in the front and just untucks the rear out off the fenders.

If you use a 7" bag in the rear, be sure to check for lots of room between the bag and the exhaust!
Most of these cars have had a dual exhaust setup installed at some point, and if it was done before the bags it tends to run a little too close to them...
Don't get me wrong, I love selling bags, but I'd prefer to only do it once per vehicle!!

-Phil at FBI

Edited: 10/18/2007 8:33:36 PM by marcus760

Edited: 10/18/2007 8:31:44 PM by marcus760



i didn't have to cut the spring pocket at all i also have all inner fenders in place and it lays with 20's if i get some drop spindles it would lay with 22's,i had to dump the exhaust out right before the rear axle,if you check my profile you can see it gets up real good the front crossmember sits flat but the way the frame is built you would need a z notch to make it lay but they look good non the less also got my brackets from f.b.i. works perfect...

http://www.gravity-werx.com/index.asp?PageAction=VIEWPROD&ProdID=1265

the fronts

thanks for all the help i hope he likes it on 22s he wants it to look like it gets alot of lift so thats the reason for he datons so it will clear the tires buy more givin it the look that it get more lift then it does.