easiest and least expensive way to bag a 1993

i got a 1993 ex cab 1500. I want it to lay out completely. it's got a 4/6 belltech drop on it, on 245-40-20s. I need new tires soon, and i am going to go with 255-35's, so they will be smaller.

and no one mention the KP 6 link. It's way overpriced in my opinion. I would actually like to do a wishbone 3 link, but keep my gas tank in stock location.

How big do the bag cups need to be?

Any particular problems I might run into? besides the exhaust?

basically I guess what I am asking, is what dimensions for the front bag cups and maybe a pic or two of the rear setup without the KP KIT and the gas tank in stock location.

blitch check out www.fullsizechevy.com/forums

i already have everyone on there swears by the way expensive KP kit, and I want to spend not so much..

Ekstensive 2 link is the best and easiest way to go.. Slide it over your frame.... weld it on... easy as that...

and how much does that run?

Lol yeah FSC.com is faithful as hell to the 6 link. I would do either suicidedoors or kp's parallel 4 link with the panhard bar, and an 8inch notch and bridge kit from suicide. run you about 500 bucks for notch kit and kp link. then just raise the gas tank about an inch, they usually section the actual crossmember and move the mounts upward. for 20's i think u can run a 2inch lower cup and 3 inch upper cup and that will put you good lift and still hammer the frame. (im not positive on those dimensons, i run 22's) only other thing is the tranny crossmember bolts stick way lower than the frame u will need to come up with a new way to mount the crossmember unless u dont mind it laying at a slant and your not planning on draggin.

Killer rides has it for $650... I dunno how much it runs straight from Ekstensive ya might get it a lil cheaper from them... Still not a bad price considering how easy it is to set up..

i found my stuff on craigslist.com great deal too. Remember when you look for cheaper stuff chances get higher of stuff breaking.