What is the best way to drill a whole in a gas tank without getting any shavings inside? I am running a return line to an aluminum tank that only has one line going in or coming out... I don't want to have to remove the tank to shake the shavings out... What is the best way to go about doing this?
Thanks everyone,Mark
bmxr4life87
+1y
ive heard that coating your drill bit in vasolene will keep you from dropping chips, its worth a shot??
JayMac
+1y
you can take a shop vac, attach it to the single opening,and set it for it will blow out. just be sure to wear safety glasses.
jmn444
+1y
also, stopping repeatedly to clean it up before you break thru will minimize shavings...