Lets see your winter projects (doesnt have to be mini related)

Edited: 12/21/2006 10:26:40 PM by SunDown

Alright guys, I know we have seen a couple of these posts before but now is the season most of us are working on something if not our mini's. I want to see what you all are working on this "winter" season.

I'll kick it off. We just moved into a new house so my garage is in TOTAL disarray right now. However I can

sweeeeetheres mine

check it out in my profile

Here's some not so recent pics of my frame I'm building for the Dodge. SFBD to the doors on 24's. Debut date is Feb. 24 at Tex Mex.

Edited: 12/21/2006 11:18:05 PM by FreakwitaFro

Originally posted by 4uh8rs





not tryin to jack the thread but is there an advantage to havin that bar that is connected to the cantilever arm move rather than bein mounted solid? i have no experience with fabrication but i had a similar idea for a frame under axle design using a cantilever setup but the pivoting point of the cantilever arm would be solid. juss kinda curious.

Nissan Silvia Headlight conversion...New 420A engine...CSI Stage 2 turbo kit...As you can see Im going to busy as hell this winter...Also planning to tub front/rear to lay unibody on 20's, but will roll on 19's!!

THIS WAS THE 1ST THAT I HAVE DONE....I HAD IT SOLID MOUNTED WITH TACKS JUST TO DO THE WHOLE TRIAL AND ERROR THING....IT PULLED LOSE FROM THE TACKS AND THE ARM COULDNT PIVOT AS MUCH AS IT NEED ...SO WE ADDED THE ROD END AND THIS WHAT U GET.IT WORKS AWSOME.....LIKE I SAID THIS IS MY 1ST CANTI TYPE SET UP I MAY HAVE DONE IT DIFFERENT THAN I WAS SUPPOSED TO BUT IT WORKS SO SOMETHING IS RIGHT

body dropping & shaving the neon

I need to get this thing painted

im putting a 2007 escaliad front end on my 2001 chevy silverado. my debut at forbidden march 13!