where did you guys decide to mount your solenoids

damn thats crazy jerry,i bet that bitch is crazy fast and loud,what kind of valves are them?????yea mine are mounted on the drivers side under my cab on the frame,its a good place till one of them stick,lol

Originally posted by thacru78



I mounted mine directly to the bag. I'm running nitrogen and didn't want to waste air filling the lines and the bags everytime I lift. Plus it's super fast and really loud.

mounted mine between fuel filter and gas tank on the frame. tight fit but super clean and speed is fast for air. 1/2 copper lines..? to you jerry ? whats that straw looking line for?

There ASCO valves. 1/2 fills 3/8 dumps. I have 1/8 spacers in the dumps cause there so fast. I won't buy nothing but asco for now on. They are awesome. I've used smc before and these are way better and less expensive. I bent on because i hit it with a sledge on accident. It started leaking. So i took it apart and straightened everything out. Works like a charm. The straw like tubing is what my air line and wires are ran through. I strung all my ailine and wires through the line and then ran them. THis way I didn't have to worry about an airline or wire getting cut or leaking.

the crazyiest valves i have ever heard was the ekmw (herin valves)valves that i had on my white truck they were 3/8 and sounded crazy on just the comp at 150 psi,my buddy ran helium at 300 psi and he said they sounded like a gun going off everytime u hit the up

thats cool jerry just courios..i have 1/2 gcs on my ride with no problems. have 2 of the 3/8 ekmw looking for 2 more, goin to put them on my project..

mine are all on the inside of the framerail next to the tranny crossmember

keeps them nice and warm for driving in the snow

yea killa i wish i could find 4 of them and i would do away with these gc450z

I have all of my valves mounted directly to my tank in the back under my bed. I have the tank in between the frame rails and the valves are all facing foward from that. I have never had any problems with my valves being "in the elements" but then again I don't live in some of the extreme conditions that other people do. I mean, I don't even drive my shit in the rain!!! The valves I am running though are from Slam Specialties and they are the best. They are the DSV valves, or Digital Stealth Valves, and they are dual acting. Meaning I can either use them with their 1/2 inch and have some crazy speed or I can flip a switch and use them as a .060 Direct Acting valve which makes it nice and slow. I usually use the slow part, because it get's more looks than just the loud popping , or whatever you call it, and it's not as hard on the truck. Good Luck!!

Edited: 11/29/2006 6:43:16 PM by ShavedMazda

I mounted my rear valves right on top of the bags and put the front valves on my bar that runs from notch to notch. The rear is very fast obviously and before i got silencers when i would dump the rear it seriously sounded like a gun was going off and was funny as hell to scare people while rolling through a mall parking lot or pulling into a gas station haha

Here is another view of my setup