Street Source is shutting down April 30th, 2026. Read the announcement
How do people make these spikes?
890 views
27 replies
20 following
How do people make these spikes?
jcordova
+1y
Figured it would be pretty tough to make them from a flat peice of sheet metal....
mtm
+1y
Originally posted by bdroppeddak
im assuming by hand made he means a manual lathe with a taper attachment....
thats how i would do it or offset the tailstock.
im assuming by hand made he means a manual lathe with a taper attachment....
thats how i would do it or offset the tailstock.
bdroppeddak
+1y
he is good with metal, maybe he got some solid stock and used a grinder then metalfinished it?
Jance Customs
+1y
That looks cool and dangerous too. What vehicle is the frame for?
Low_SST
+1y
Im sure he did them on a lathe, thats realy the only way to make a perfectly symmetrical spike. I would offset the tailstock and cut it like a taper but to a point.
jcordova
+1y
I'm not sure what will be sitting on it....
9
96canedcivic
+1y
its a sonoma its fuckin bad ass they have been working on it at the little shop for a long time now.
B
bagdb2200
+1y
^^yea^^
The frame belongs to this truck.
http://www.streetsourcemag.com/ViewOwnerProfile.aspx?Profileid=28849
The frame belongs to this truck.
http://www.streetsourcemag.com/ViewOwnerProfile.aspx?Profileid=28849
jcordova
+1y
jcordova
+1y
Related Discussions in Mini Truckin General
Thread
Posts
Last Post