Street Source is shutting down April 30th, 2026. Read the announcement
Whats the correct angle to mount your engine? Correct Pinion angle?
391 views
10 replies
8 following
B
Whats the correct angle to mount your engine? Correct Pinion angle?
S
smallz
+1y
Whats the correct angle to mount your motor and tranny at? And whats the correct pinion angle?
bodydropped85
+1y
motor and tranny mounted, pinion angle should be 2degrees positive.
D
draggintoy
+1y
I've read on numerous sites that the carb base should be zero and tanny should be aprox 2 to 3 degrees
suckafree
+1y
I always thought motors were at a 7 degree.
S
smallz
+1y
Ive heard 2-3 and also ive heard 5-6. When they were doin mikes toyota in minitruckin they said, 5-6 on the motor.
Dejavu
+1y
on the intake flange on top it should be 0 which will give your motor about a 3 degree down slant twords the back.
tofnlows10
+1y
heard 5 degrees..
....but if u are bagged it can be less...cause if u drive w/ the front up more then the back the oil will get to the pump fine...
....but if u are bagged it can be less...cause if u drive w/ the front up more then the back the oil will get to the pump fine...
D
draggintoy
+1y
if ya put the carb base ( assuming your running a carb'd motor) at zero i think the actual engine is about 3 derees. but the carb base is zero.
S
smallz
+1y
Im running a fuel injected motor. What if i put a degree level on the valve covers would i be able to use that degree as the overall engine degree?
S
smallz
+1y
Anyone know for sure? I think im gunna mount it at 2 or 3 Degrees
Related Discussions in Mini Truckin General
Thread
Posts
Last Post