K
More #^^#@%&Work
truck action
+1y
So with the new compressor in place I started moving forward with I plan to do only to find more fucking work to do!! There was a small contamination in the paint at the bed, so if I'm doing paint work at the bed thought I'd dig into this spot,found a problem, small rust hole that went up into the rear tub! So cut clean & weld up = more work!! Will try to spot paint & clear coat, & wet sand out! If a no match will have to reshoot the whole bed,upper & lower!!!!!!!
Post was last edited on Feb 11, 2016 02:31. Edited 1
time.
baha
+1y
Bummer, I know how that feels, I'm no paint expert but I bet getting a good match is a challenge.
truck action
+1y
The more I think about it the more I think I'll just reshoot top& bottom, one coat clear coat,wet sand, lay ghost flames out ,shot them & clear coat all several coats! Why waste the base & clear coat !!
Post was last edited on Feb 15, 2016 04:01. Edited 2
times.
truck action
+1y
WHY WHEN i ADD A REPLY THE FIRST PHOTO'S GO UP????!!!!
baha
+1y
When you upload photos, it doesn't add them to your thread automatically so you can add a comment first.