56 ford fairlane dash in mazda
1674 views
15 replies
9 following
K
56 ford fairlane dash in mazda
fuknlow25
+1y
fuknlow25
+1y
FireCrotch
+1y
same dash is going in my ranger
FireCrotch
+1y
smctoy
+1y
looks awesome
FADE2BLK94
+1y
Same dash is in my ranger! lol!
FADE2BLK94
+1y
Edited: 12/3/2010 9:13:46 PM by FADE2BLK94
Edited: 12/3/2010 9:10:34 PM by FADE2BLK94
Looks good! Mazda cab must be wider inside, on mine I sectioned 2 3/8" out of the center (right through the middle of the speaker grill and the ash tray opening) and cut off one inch on each side and capped them like you did to get it to fit and line up with the steering column. You can see it here >>>>
Edited: 12/3/2010 9:10:34 PM by FADE2BLK94
Looks good! Mazda cab must be wider inside, on mine I sectioned 2 3/8" out of the center (right through the middle of the speaker grill and the ash tray opening) and cut off one inch on each side and capped them like you did to get it to fit and line up with the steering column. You can see it here >>>>
fuknlow25
+1y
yeah i think mazda is wider ... cus it was like 1" of the driver and like 2" of the pass.. ... lucky i didnt have to cut it down the middle
FireCrotch
+1y
well it is the nicest steel ford dash!
FADE2BLK94
+1y
Yes it is, I didnt even know what mine was. Stumbled upon it walking through a swap meet at Charlotte motor speedway in the spring of '07, picked it up took it home and cut it to fit. At that point all I knew was is was from a 56 Ford. Had to dig around online a bit to see what it was from, lol.