Sheetmetal bed floor

I wanna see some pics of the framing you guys did on your sheet metal bed floor. Basically where you connected to the bed sides.

Edited: 5/15/2010 1:42:49 AM by roadracer

 on my mazda i ran 1.5 x 1.5 x 14 ga tube across the floor and welded to the ribs. ran the tubes little longer than the inside of the bed rails.then for the side sheetmetal i ran a pc of 2" flat galv up to the bottom of the bed rail and welded there. solid! ran pc of angle iron from front to rear to weld side sheet metal to.

Heres a bottom pic. The sides are just vertical 16ga sheetmetal with radiused corners welded to the bedside pinch.

hey Dill, show off some of your past work too.