K
i got the yota clip
THE LOW RANGER
+1y
i finally got the yota clip and now i need some pics of bag brackets and i also noticed the uper control arm is going to be in the way of the streeing shaft comming out of the streering box
mindlissmetalfab
+1y
You will likely need to modify your steering shaft with an extra U-joint and a rod end. Search the toyota profiles for some examples.
airrideluvtruck
+1y
You can also notch the upper control arm if theres no room to run the shaft around it.
SunsetRanger
+1y
Edited: 6/12/2009 2:53:27 AM by SunsetRanger
I'll try to get some pics of how we routed the steering on my truck. Essentially what we did was use 3 joints. It went toyota steering box to smooth weld-on then a double weld-on to mate with a weld-on to a Ford D joint. We also had to use 2 heim joints to stabilize the steering. Here are some pics of the bag brackets that were built for my frame. If you want to see more pics of the truck and the build so far you can go here.. http://s71.photobucket.com/albums/i141/myth619/willtruck/
I'll try to get some pics of how we routed the steering on my truck. Essentially what we did was use 3 joints. It went toyota steering box to smooth weld-on then a double weld-on to mate with a weld-on to a Ford D joint. We also had to use 2 heim joints to stabilize the steering. Here are some pics of the bag brackets that were built for my frame. If you want to see more pics of the truck and the build so far you can go here.. http://s71.photobucket.com/albums/i141/myth619/willtruck/
