Gettin alot of work done,lookin good!What did that steering rack come off of? Do you know where the bolt in joints for the steering and upper arm came from?
layedoutnissan
+1y
looking good.
lukedogg
+1y
Man, this truck is looking great! Keep posting updates...
ixenn
+1y
Edited: 11/17/2008 3:11:56 AM by ixenn
Edited: 6/13/2008 1:40:48 AM by ixenn
Connecting pieces finally finished and installed (uniballs up top and heims down below 3/4 from wheel)
Picture with both installed
Not to bad of lift in back
Working on wiring up the switches - its done now i'll have to take another picture
I also did alot of welding on the bed and will start sheetmetaling it tomorrow. I have to take the truck to ford so they can reprogram the entire PATS system.
ixenn
+1y
Edited: 6/13/2008 2:01:07 AM by ixenn
A little video for fun.
ixenn
+1y
Edited: 11/17/2008 3:13:12 AM by ixenn
Edited: 6/13/2008 11:19:34 PM by ixenn
Progress on right side
Notice how I didn't have to cut the fender after all :(
Sheetmetal finished: need to finish welding everything now
Test fit on truck and i think it'll look better with the middle pieces gone and leave the wells open(need to finish cutting the other part off.
Shot of the rear, barely misses the fuel cell
Corner
Corner
Took a picture of the truck after it got back from ford
Another
So as you can see got the bed pretty much finished except for welding and stuff, at least the fabbing is done. I also rented a trailer and loaded up the truck to take it to Ford. Ford programmed the computer and setup the PATS system. It now turns over when turning the key! thats a big step.