Stockfloored 720

Looking good man!

Are they the stock dimensions? Any advantages to them over the Stocks (like balljoint angle?)

Edited: 3/1/2008 3:14:24 AM by TwistedMinis

Originally posted by LoAss720



Looking good man!

Are they the stock dimensions? Any advantages to them over the Stocks (like balljoint angle?)

Yeah they are the same as stock. Excep the balljoint plate is angled to what I feel is the optimum angle. It will lay on the 18s with room to spare, and get plenty of lift. I flipped the control arms just to get it to lay, and it only got like 6 inches of lift. So I cut and angled the arms until I got an angle I felt was good and went with that. I'll take a picture next to a stock arm when I put one of them together.

Also, they should clear the bag mounts better.

Nice work dude.

Fuck yeah, Coors Original! Can't wait to go to the US next week.

man lookn damn good u gonna make the for a mazduh ??? if so holla at me cause i had to butcher my uppers cause it was hittn my bag at lockup which is about 200 psi or so ....low intentions 4 life

Originally posted by iLLblazer



Nice work dude.

Fuck yeah, Coors Original! Can't wait to go to the US next week.

Thanks Joel. Where you going in the US?

Originally posted by ericlaydsonomaga



man lookn damn good u gonna make the for a mazduh ??? if so holla at me cause i had to butcher my uppers cause it was hittn my bag at lockup which is about 200 psi or so ....low intentions 4 life

I don't know. Maybe if I bag another one. But I don't have anything to go off of.

Originally posted by TwistedMinis



Originally posted by iLLblazer



Nice work dude.

Fuck yeah, Coors Original! Can't wait to go to the US next week.

Thanks Joel. Where you going in the US?



We are heading to Minneapolis for the Taste of Chaos tour!! can't wait.

That should be a good show. I think it comes somewhere near me later this year.

I got the second arm today and then mocked one up. On final assembly it will get a single .250" thick washer on the inside of the bushings, rather than two .125" washers, and I will make an aluminum or stainless washer for the outside that is the correct size for the new bushings. I just put them together with the stock parts for now.Now I get to cut off the old front bag brackets and make new ones...

Now you can also see why that one side is bent the way it is, in the second to last picture.

hey seth are those uniballs? im lookin for a balljoint that i can get alot of travel out of. im about to get one off upper arms made