K
Slammed
foulmouth79
+1y
i rarely post here, but dayum...just dayum. you did all that in your garage. i'm speachless
Uncle Fester
+1y
Absolutely lovely to see the level of work there. Can't wait to see the end result. If you can I would love to know more about those gauges that tell you the height of the ride, sure take the guess work out of adjustability.
spraybomb
+1y
WOW, is all I can say! I hope to someday reach a level of craftsmanship that equals yours.
dragmatic
+1y
Mad props go out to the garage builders! That is very nice work. I myself would have a hard time doing anything else to the truck. It looks nearly perfect as it sits.
still2high
+1y
wow, that is some sweet ass work.
Cruz Lo
+1y
Originally posted by Uncle Fester
Absolutely lovely to see the level of work there. Can't wait to see the end result. If you can I would love to know more about those gauges that tell you the height of the ride, sure take the guess work out of adjustability.
Thank you for the compliment.
I won't even go into how hard it was to find the right parts. well maybe just a little bit LOL.
US Digital is the company.ED3 Displays.H6MD Hi resolution encoders with the Index option (lets the encoders find "Home position" upon start up after power down). The displays can be calibrated and set up to work with the range of motion once installed. So like in my case the display shows the distance of the rockers off the ground.Then of course the aligned ride height.
I had to fab the arms, mounts etc..
This is an actual measuring system! Not like a "repeat" of a set position.
The cost is there, but is is less expensive than Dakota's repeat system, and a lot less than a 24" tire!
Absolutely lovely to see the level of work there. Can't wait to see the end result. If you can I would love to know more about those gauges that tell you the height of the ride, sure take the guess work out of adjustability.
Thank you for the compliment.
I won't even go into how hard it was to find the right parts. well maybe just a little bit LOL.
US Digital is the company.ED3 Displays.H6MD Hi resolution encoders with the Index option (lets the encoders find "Home position" upon start up after power down). The displays can be calibrated and set up to work with the range of motion once installed. So like in my case the display shows the distance of the rockers off the ground.Then of course the aligned ride height.
I had to fab the arms, mounts etc..
This is an actual measuring system! Not like a "repeat" of a set position.
The cost is there, but is is less expensive than Dakota's repeat system, and a lot less than a 24" tire!
LowRamON20s
+1y
lemme know if u wanna sell it
lucky_brew
+1y
you are beyond a fabber! a true engineering genius! by the looks of it i think its more than your average rodent wheel spinning in that head of yours... i am assuming you dont work at mcdonalds!
onelow96cs
+1y
I love your truck. Awsome job!.. That measuring system looks like a awsome set up!
///RELAXED 720
+1y
I was just talkin about findin a system that would measure height to use w. hdyros ...Im guessin that same system or something like it would work for that correct? Oh and again I just wanna say HOLY SHIT !!!!!!!!!