not gettin any spark

i have a 94' chevy c1500 and its not getting any spark i put a new MSD Blaster GM Coil and a Accel ignition control module and MSD Distributor Cap and Rotor and still nothing anyone got any ideas for me???? its a 5.7 350 tbi thanks

is the distibutor rotor turning?

ya i just went and look it turns

Edited: 2/20/2007 9:31:20 PM by HOLCOMBE347

i just had this problem wih my toyota after i put the motor back in it.. somehow a ground came disconnected in the cab of the truck. i just cut the ground to the coil and grounded it to the body...started right up after that.

nice ill have to try that thanks

I had a similar problem. I had a 6AL, MSD coil & MSD ready to run distributer. I went through all the wiring 10 times and it was good. I did the trouble shooting in the manual and I could get the 6AL to fire, but it would not fire through the distributer. I had to send the brand new distributer to MSD. They replaced the module under the board and it fired right up after.

IM me if you are still stuck.