stock floored, round tube chassis Ford f-150

Looks good

siiiiick work.

not to be negative or anything, but am i the only one who can picture that whole back half bending after driving it for a little? from the pics, the only support it has is the two half circles of inch and a half tubing to support it.

thats y he did 2 peices with the bar in the middle so it wont bend,plus the bed should be some support also

im talking about bending right behind the cab where it is joined to the box tubing.

he has the two half circles connecting the two halves, and more than likely the round tubing goes inside the frame a bit.

Edited: 3/18/2007 5:35:33 PM by Pneufab

t

Why was the pieces not cut as 2 45* angles? I have seen this a few times lately. It may not make difference at all structurally, but appearance based, my opinion is two 45's is much cleaner.I would also, (personally again) gusset those corners for the sheer fact of being safe. Once again, probably isn't needed, but whats a little custom gusset gunna hurt?