Hackjob S10 project I picked up...

THE BEST JOB I HAVE EVER SEEN

haha... holy shit man, good luck pulling everything together! Progress looks good so far

Originally posted by Brill

Yes, that IS a chainsaw blade thing. It served no point that we could figure out.



I bet you any money that is there to hold the muffler down against the pavement when dragging instead of letting it get pushed up when you lay it out.

But its still pretty funny. Good luck with the rebuild!

See why I need a new bed, this one is fucked.. But my 4-link is pretty..

Meh.. still need to cut off that piece of shit over the pumpkin..

I think you need to incorperate the chainsaw BAR in there somewhere as your redoing the truck, that would be hilarious reminder, of what it was.

Haha, I might make something out of it..

here is another shot..

Originally posted by Brill



Haha, I might make something out of it..

here is another shot..



crap looks like you are not really gonna have much room for adjustment on that 4-link

Edited: 11/22/2006 12:17:01 AM by Brill

It looks weird in the pic.. but there is plenty of room... I have a little more adjusting to do on the upper bars to get it perfect..

my bad looked like the bars were adjusted all the way in. looks good though.

Edited: 11/22/2006 12:34:17 AM by Brill

They are currently all the wya in.. that is the only way I could get that stupid mount over the pumpkin to clear the crossmember when laid out...

At ride height.. with the bar ends screwed out and pinon angle set.. all is well.. but if I drop the ass, the two bars hit..

The shop that put all that shit together.. DID NOT SET THE PINON ANGLE before welding the xmember on and the pumpkin humping piece of junk there..

Its gettin cut tomorrow.

Thanks for the props... =)