orifice

243 views
9 replies
10 following
K
orifice
s10soolow avatar
s10soolow
+1y
Whats a typical valve orifice size?
Dragin Dakota avatar
Dragin Dakota
+1y
1/2" or 15mm is pretty standard right now. I think that 1/2" fills and 3/8" dumps (10mm) is a pretty good combo.
periportfd avatar
periportfd
+1y
Parker 1/2" ports and either 1/2" or 5/8" orifice. I get 5/8".
bdroppeddak avatar
bdroppeddak
+1y
5/8" is the goin rate for most valves in the market now.
periportfd avatar
periportfd
+1y
Yeah Cris, I think the other guy is confusing port and orifice. The orifice is the area pictured here with the parker valve sticking in it.
post photo
no1lowr avatar
no1lowr
+1y
if you go parker go 3/8 port 5/8 orifice, you wont lose a damn instant in speed, plus you can throw sand in parkers!
periportfd avatar
periportfd
+1y
Originally posted by NO1LOWR



if you go parker go 3/8 port 5/8 orifice, you wont lose a damn instant in speed, plus you can throw sand in parkers!

I've read that a couple times now. I'm a loyal Parker guy so...tell us your sand story already. Parker....the Glock of valves.
draggin20s avatar
draggin20s
+1y
Where are you guys going to get parker valves? I know they have parker stores but I don't think that there is one near me... at least not one that I know of.
bdroppeddak avatar
bdroppeddak
+1y
i goto the parker store www.gravity-werx.com is a good source mike sell parker valves and any fittings they have.
forbidden avatar
forbidden
+1y
We have the Parkers on our site also. Great prices in stock ready to go..

Parker 3/8" $45.99Parker 1/2" $50.99