how to fit an s10 in a 6x8 trailer.....

Edited: 11/26/2005 11:42:39 AM by bagged85

Edited: 11/25/2005 12:29:33 PM by bagged85



it was a pile of shit bodydropped w/ sheet metal screws and fiberglass roof cut off bout 10 cans of bondo on the rear end. im just keepin the frame its not hurt that bad. will be used for the next project...

this is the next project. i suck at photo shop so is here is my rendition in paint lol

thats the best mod ive seen on a s-10 yet ha ha

GO GO project commando

Haha.. nice

Whats wrong with sheetmetal screws?

That is definite one way to do it.

towing fully assembled trucks is way over-rated...

yup ima take it to thescrap yard tomm and prob get 20 bux if that!

I always wanted to do one of those Jeep trucks. but id use a cherokee body for the 4 doors and use the rear of the truck cab and the bed. then lay it out on some 18s and 22s for a street rod look.
put in a Ford 351 with some aluminum heads. cut about 4 inches out of thew roof, shave the drip rails, vertical billet grille with some tri bar headlights. no front bumper just a couple nerf bars, lED caddy tails in the bed with the rear quarters layed forward like Cadzilla.

too little money, far less time.

Originally posted by bagged85



Edited: 11/25/2005 12:29:33 PM by bagged85



it was a pile of shit bodydropped w/ sheet metal screws and fiberglass roof cut off bout 10 cans of bondo on the rear end. im just keepin the frame its not hurt that bad. will be used for the next project...

this is the next project. i suck at photo shop so is here is my rendition in paint lol

hey thats what my truck looks like