bagging the front of a s-10

Just bolt the bag in... mark where it hits and cut it out... leave about an inch all that way around the bag. Once you get in there, you will see what you need to do.

Go to s10forum.com theyll help u out

i offset my upper cup by 3/4" with Slam RS72's. you will def need to trim the spring pocket with both 2500's and 2600's. I am not sure with stock wheels with low pros, but most the time the tire will hit the inner fenders before you lay out so you may have to take them out. you will need drop spindles as well as modding the lower control arms to lay frame as well as moding the exhaust.

Good call on the exhaust, I forgot that I had my y-pipe changed to connect under the driveshaft instead of the tranny. Mine laid out with 205/40/17 with spindles and no modifications to the control arms. If you go with that total hieght you will not have to ditch the fenders.

I didn't modify anything w/ my control arms. just notch the frame where they hit. You shouldn't need to take out the fenders w/ the low pros, but you will w/ bigger wheels.

I mashed the shit out of my exhaust, so I would get the part hanging down reworked.

I mashed the shit out of my exhaust, so I would get the part hanging down reworked.