95 ram bags and bodydrop

your prolly gonna have to wait til barnyard releases their ram control arms

do you still have your stock parts?if so,get the spindles and a set of re-angled uppers.spindles will get you in the ground with 22s,stock lowers new uppers.wat i HAD.

i plan on a set of barnyard ones and mabey spindles for good measure. i wanna lay with as little camber as possible on a 22 in the front and a 24 in a rear.

nope no stock stuff here i figure i might try not to use aftermarket spindles since they $$$$ from belltech, so i think i wil ltry to bag it on what i ahve and go from there

Originally posted by low95xlt



nope no stock stuff here i figure i might try not to use aftermarket spindles since they $$$$ from belltech, so i think i wil ltry to bag it on what i ahve and go from there

im pretty sure it wont lay. you need some spindles or control arms.

got aftermarket a armss upper and lower already on there, jsut have to redo to accept bags

theres a guy on here with a bagged and bd dodge on 22s without spindles.dont remeber his sn though.but without askin him,your not goin to get it to lay out without either spindles or doin some relocating.

^werd up mine binds like .25 from laying flat out on the crossmember.

Originally posted by Low_SST



^werd up mine binds like .25 from laying flat out on the crossmember.

how is your done?wen mine was roliin,it Hlayed on the front x-member

im rolling djm arms, no shocks or sway bar, but i think my control arm is still hitting in back of the spring pocket. my upper control arm is binding on my balljoint. My back isnt bagged either so i think that might get me lower once that goes on.