2013 Titan by Tre5 Customs

Great work!!!

I would rather watch the build on here... Looks good bud. What made you decide to do the tabs horizontal vs Vert. for the cross member side of the 3 link? Very clean bed work too.

Looks great!

Bad ass!

Thanks guys. I try to always run the heim bolt vertical on the center of the upper link pivot. The heim is much stronger that way. The triangulated link is what centers the axle, so the load on the heim is horizontal. If you place the bolt horizontal, then heim can blow out the side. If you place the bolt vertical, the heim can not blow out the side... hence much stronger. Depending on the length of the link, a 3/4" heim with 5/8" misalignment spacers is good for more than enough articulation.

Man you do some amazing work!!!!!!!!

Badass truck. Thanks for sharing the build.

I wish there were more of these being built. They look great on the ground. Nice work

so nice!! love your work!!

Looks good!!