Street Source is shutting down April 30th, 2026. Read the announcement
The Story So Far...baggin' an 87
5770 views
151 replies
73 following
The Story So Far...baggin' an 87
bodydropped85
+1y
thats fucking badass! is it gona lay rockers?
tealchevy
+1y
no rockers. laying frame....but flat front to back. The pinch will be an inch off the ground
okcderek
+1y
I been checking out some of your work on DFWmini..........you do bad ass work. Thats a really clean Z you did to this truck...
P
pasomike
+1y
did they have to adjust the motor or trans when they z'd the frame? im thinkin of doin mine but wanna find out wat all i have to do first
tealchevy
+1y
Just for clarification....I didnt do the metalwork. All of the metalwork was done by Keith at Nfamus Air Suspension in Mansfield
tealchevy
+1y
oh, and that last picture is WITHOUT drop spindles
LndRanger86
+1y
SO THE TRUCK WILL LAY FULL FRAME WITH JUST THE Z DONE? AND IT WILL ONLY LAY ABOUT 1" OFF THE PINCH? WHAT ELSE IS INVOLVED?
tealchevy
+1y
pulled both tanks, new transmission crossmember, and the Z'ing of the front crossmember. Those are all the things that hang below the true frame.
LndRanger86
+1y
THANKS
tealchevy
+1y
ill have the truck back in my possession soon, so I can answer a lot more questions then
Related Discussions in Full Size Truckin General
Thread
Posts
Last Post
43
last post by
someotherguy +1y
122
last post by
bowtiejc +1y