Prerunner fenders/bedsides on a lowered truck?

anybody seen it done? ive been thinking about getting some fenders and bedsides for my 92 yota. might look ricer-ish, but i think it would be badass with some dished out rims and wide tires. ill try messin with photoshop if i can find some good pics of that truck with the panels.

i've been planing a project like that just havent got to it yet

i kinda like the look of the downey flat fender 4wd style. they and glassworks unlimited have stock look bedsides too. not the kind where it has alot cut off the rear overhang.

a while back i was gonna get the one piece tundra front end and channel and section it to fit a yota but never got around to it. i think it would be badass!!

like narrow it down? i think if i did this, id probably cut the wheel well areas, and drop them down. so that its a flare, but not a rise. stock-ish looking wheel well, but flared the hell out.

Did It back in 99-2000 to a Nissan HB the same one I have now. It was kool at first I ran a 15x8 rev offset and could drag body and still have full turn. But that was some thing that you either like it or you hate it!!

any pictures?