doing a bodydrop and was wondering about the cooling fan

I'm doing a stock floor bodydrop on my 96 chevy fullsize. I have seen were were people have recommend a electric fan. I was wondering is it possible to use a single fan or do I need to get a dual fan.

Flex a lite makes a kit everything you need!
Expensive, but you will never overheat and it makes your AC work better!
http://store.summitracing.com/partdetail.asp?autofilter=1&part=FLX%2D280&N=700+4294908216+4294924744+115&autoview=sku

i would use a dual fan if i were you,
i tride to put a single fan on a 98 chevy full and when you sat still it would start to over heat every time , dual fan fixed the problem..

Get you a fan off ebay. I think I paid aroudn $75 for mine. It pushes 3800 cfm which is plenty for any motor. Then i bought a relay and a thermostat from autozone. WHole setup cost me about $120. Never had any problems with it. The flex-a-lite kits are a little pricey. But they are good fans. Mines a spal fan i believe

i just modified the shroud on mine and kept the stock clutch fan

v8 camaro and firebird e-fan's are the exact size you need. Got a set off a wrecked car on my truck.