Street Source is shutting down April 30th, 2026. Read the announcement
What gauge metal to use on floor of cab?
keele
+1y
What gauge metal are you guys using on your floors in your cab. 16 gauge or 18 gauge?
lowdyme
+1y
i used 16 gauge
D
dragthatbitch
+1y
16 or 14, it all depends on the structure under it.
keele
+1y
It will just be going over where I had to channel thru my cab alittle. The frame is only about 1/2" to 3/4" thru
jdauer02
+1y
I used 16 ga. with 3/4 square stock under it and its very strong. you should be good with 16.
C
CiViS300
+1y
16 ga. is more than enough you could even use 18 ga. and roll some beads in it to give it that extra strength.
Related Discussions in Body work and Paint
Thread
Posts
Last Post
4
G
last post by
gkc301 +1y
5
last post by
Bizzo +1y
0
R
last post by
Racer911 +1y