Street Source is shutting down April 30th, 2026. Read the announcement
what gauge steel
22dragn
+1y
what gauge steel should i use for a bed floor and sides? i'm only going to raise the bed floor about 2-3" and sheet everything else in.
1 LoWfUKn RaM
+1y
14-16 would do
eks10BDRG-N
+1y
did mine in 16guage
M
m2edragger
+1y
Originally posted by eks10BDRG-N
did mine in 16guage
yulp me too
did mine in 16guage
yulp me too
22dragn
+1y
would 18 be to thin
S
sjudd86
+1y
do 16 guage.
O
OSL
+1y
18 WOULD BE FINE,CHECK OUT MY PROFILE NO WARPING AT ALL
M
mccustomize
+1y
did you guys build a frame for it? or just the sheetmetal and what did you do to control the warping?
S
ShaveDnFlamed99
+1y
i would use 16 gauge and use 1/2" square tube and make a frame to make sure everything gets built square and to control warping
FluffyFreak
+1y
would 14 be good for the floor of a suburban too?
Related Discussions in Body work and Paint
Thread
Posts
Last Post
4
G
last post by
gkc301 +1y
5
last post by
Bizzo +1y
0
R
last post by
Racer911 +1y