bagged s10 driveshaft hits the cab why?????
741 views
3 replies
4 following
S
bagged s10 driveshaft hits the cab why?????
G
greendime
+1y
i just got done bagging my 97 s10 and when i lay out the drive shaft hits the cab floor pretty bad is this a common problem or is cause my pinion angle any help would be great as soon as this is fixed i can drag!!!
B
bertristerf150hd
+1y
one piece shaft normal
NRChopShop
+1y
on std cabs, yes it is common. make sure your pinion angle is correct and notch the cab accordingly. if you have a reverse or 50/50 link setup it will only make it worse.
Low_SST
+1y
Originally posted by minimazda5
Originally posted by NRChopShop
on std cabs, yes it is common. make sure your pinion angle is correct and notch the cab accordingly. if you have a reverse or 50/50 link setup it will only make it worse.
true true true!...one ?...whats a 50/50 link setup???
lower bars foreward uppers reverse or visa versa.
Originally posted by NRChopShop
on std cabs, yes it is common. make sure your pinion angle is correct and notch the cab accordingly. if you have a reverse or 50/50 link setup it will only make it worse.
true true true!...one ?...whats a 50/50 link setup???
lower bars foreward uppers reverse or visa versa.