Street Source is shutting down April 30th, 2026. Read the announcement
F
fluxcore/bodywork
F
fuller
+1y
Edited: 1/11/2005 4:29:43 AM by Fuller
how well does a welder that uses fluxcore wire work on sheetmetal/bodywork...i have a small 110v fluxcore mig machine i can use and was wondering if it would work any good on frenching my license plate box and welding my roll pan on..and if so, what size wire would work best at the lowest heat.....Thanks..!
how well does a welder that uses fluxcore wire work on sheetmetal/bodywork...i have a small 110v fluxcore mig machine i can use and was wondering if it would work any good on frenching my license plate box and welding my roll pan on..and if so, what size wire would work best at the lowest heat.....Thanks..!
Related Discussions in Body work and Paint
Thread
Posts
Last Post
4
G
last post by
gkc301 +1y
5
last post by
Bizzo +1y
0
R
last post by
Racer911 +1y